Cisco asa 8.3 gns32/5/2024 ![]() Which allows Cisco to securely receive minimal error and health Help to improve the ASA platform by enabling anonymous reporting, Running Permanent Activation Key: 0xcb10d26a 0xa440851c 0xc9326500 0xdaa01818 0xc325eabcĬonfiguration has not been modified since last system restart. ![]() This platform has an ASA5525 VPN Premium license. Maximum Physical Interfaces : Unlimited perpetualĪn圜onnect Essentials : Disabled perpetualĪn圜onnect for Mobile : Disabled perpetualĪn圜onnect for Cisco VPN Phone : Disabled perpetualĪdvanced Endpoint Assessment : Disabled perpetualīotnet Traffic Filter : Disabled perpetual SSL/IKE microcode : CNPx-MC-SSL-SB-PLUS-0005 Hardware: ASA5525, 8192 MB RAM, CPU Lynnfield 2394 MHz, 1 CPU (4 cores)īIOS Flash MX25L6445E 0xffbb0000, 8192KBĮncryption hardware device : Cisco ASA Crypto on-board accelerator (revision 0x1) ![]() System image file is "disk0:/asa942-11-smp-k8.bin" WARNING: Failover is enabled but standby IP address is not configured for this interface.Ĭisco Adaptive Security Appliance Software Version 9.4(2)11Ĭompiled on Mon 22-Feb-16 22:54 PST by builders I explictily configure the standby IP address on the 'inside' interface since we're doing HSRP and allocate a /29 subnet.ĪSA01/pri/act(config-if)# ip address 202.78.4.6 255.255.255.128 The standby keyword is normally used in Active-Active failover where each context monitors its interface and activates failover if it multiple failed interfaces were detected. ![]() For example, if you've got limited public IP address range, you can just configure the 'outside' interface with a single public IP address. You can optionally skip the standby IP address under the context configuration and failover (and routing) would still work. I also confirmed with Cisco TAC that a 20-Security Context license ASA5500-SC-20 (vs L-ASA-SC-20) will work on a Cisco ASA 5500-X platform. The Secondary/Standby unit will inherit the Primary license when it becomes Active. You just buy and only install the license for the Primary/Active firewall unit. ![]() Before its deployment, I've upgraded both ASA to the latest code 9.4(2)11, applied and configured the 10-security context license (multiple mode).Īccording to Cisco ASA 5500-X Configuration Guide starting ASA 8.3(1), you don't need to install identical licenses (with some exceptions) on both firewall units. I've posted a blog a couple years back regarding this setup in a GNS3 environment but now I'm deploying it in the real world. I had a remote site with two Cisco ASA 5525-X firewalls deployed as an Active-Standby failover pair. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |